Grinding Mode; Adjusting Grinding; Safety Devices - Sanremo SR70 Bedienungsanleitung

GRINDING MODE

Standard
Press for the required dose using the buttons
or . The selected button will begin to
flash. When the filter holder cup is pressed,
the start microswitch activates grinding. When
the button is pressed, continuous grinding
is activated until the button is released. The
Standard mode is factory-set. To reselect it, ac-
cess the settings menu, select Grinding Mode
and then Standard. In this way, the buttons will
light up.
Automatic
Access the settings menu, select Grinding Mode
and then Automatic. For a single dose, press
the start microswitch once with the filter hold-
er cup. For a double dose, press twice quickly.
In this way, the coninuous grinding (button
and the buttons and
PRE/SEL
Access the settings menu, select Grinding Mode
and then PRE/SEL. Press the required dose us-
ing button or
remain on and active. Grinding starts when the
start microswitch is pressed by the filter holder
cup. To switch from one dose to another, press
the appropriate button. In this way, continuous
grinding (button ) is deactivated.
Direct
Access the settings menu, select Grinding
Mode and then Direct. Press the required
dose by using the button
button is pressed, continuous grinding is
activated until the button is released. In this
way, the start microswitch is deactivated
and the buttons light up.
• During the grinding process, the time is dis-
played in seconds and tenths of a second.
• The button for the selected dose flashes dur-
ing dispensing.
• After dispensing, the counters are updated.
• For counting purposes, continuous grinding
corresponds to a single dose.
are deactivated.
. The selected button will
or . When the

ADJUSTING GRINDING

In order to achieve finer or coarser grinding
and therefore vary the granulometry, use the
adjustment disk located under the hopper. To
increase the coarseness of the ground coffee,
the adjustment disk must be rotated clock-
wise, pressing the adjustment disk lock down-
wards, to decrease turn the disk anticlockwise.
The adjustment must be performed with the
motor on, and possibly without coffee between
the grinding blades.
)
It is advisable to grind small amounts of coffee
to facilitate a visual check of optimum granu-
lometry and, if required, adjust the grinding
adjustment disk. If the coffee comes out of the
espresso coffee machine very quickly, it means
that the coffee is ground too coarse. Vice versa,
if it comes out too slowly, it means the coffee
is ground too fine. Nonetheless, bear in mind
that there are many conditions liable to influ-
ence the correct supply, such as the weight of
the portions, the compacting, the espresso ma-
chine settings and the cleaning of the filters.

SAFETY DEVICES

Thermal overload protection
The grinder-doser motor is protected against
overheating resulting from overcurrents by
a thermal overload protection which, when
tripped, cuts off the power supply to the mo-
tor. If the thermal protection device should au-
tomatically turn on in the event of anomalous
operation (such as the grinding blades jam-
ming), turn off grinder-doser using the On-Off
switch, unplug it from the mains, and contact
skilled technical personnel. Never perform any
work on the grinder-doser while it is attached
to the mains, in order to prevent the motor
17
22
ENGLISH