Maintenance - Bosch ASM 32 F Bedienungsanleitung

WMV-Dresden, Ersatzteilservice für Elektrowerkzeuge, Motor- und Gartengeräte
EURO • Printed in England • BA F 016 L69 883 • ASM 32/32 F • GB • OSW 02/01
F016 L69 883.book Seite 3 Dienstag, 15. Januar 2002 8:38 08
Assembly
A Attach the handlebar 1 with the bolts and the
wing nuts to the handle assembly.
Note: Ensure that the cable clips supplied are used
to fix the cable to the handle.
C Snap together both top and bottom half of the
grassbox.
B
Attach cable to cable restraint 5 ensuring that
sufficient cable slack is available.
Remove transport packaging/label from the mower,
the blades will require adjustment - see adjusting
blades.
C
Grassbox/bag
Attach/remove the grassbox as shown. (ASM 32)
Snap together the grassbox. (ASM 32 F)
Ensure cables are not trapped when folding/unfold-
ing top handles, do not drop the handles.
Adjusting the Cutting Height
Stop, release switch lever and wait until
the motor stops before adjusting height.
The blades continue to rotate after the ma-
chine is switched off, a rotating blade can
cause injury.
D
The lawnmower can be set to several cutting
heights. For this purpose,
lever 8 outward then
sired cutting height while supporting the weight of
the mover with the other hand.
For the first cutting of the season, a high cutting ad-
justment should be selected.
Starting and Stopping
E
The blade continues to rotate for a few
seconds after the machine is switched off.
Allow the motor/blade to stop rotating be-
fore switching "on" again.
Do not rapidly switch off and on.
To aid starting push handle down to lift front
wheels.
Starting:
0
2
1
I
Stopping:
Release the switch lever 2.
13 • F016 L69 883 • 02.01
press the height of cut
move up or down to the de-
Press and hold the safety button 3.
Squeeze the switch lever 2 towards the
handle.
Release the safety button 3.
Mowing
F Place the lawnmower on the edge of the lawn,
as close to the power point as possible. Work away
from the power point.
Position the cable to opposite side (already cut) at
the end of each turn.
The blades may require adjustment, particularly be-
fore first use - see adjusting blades.
When mowing do not allow the motor to labour
particularly in heavy conditions.
When the motor labours the speed of the motor
drops and you will hear a change in the motor
sound, when this occurs stop mowing, release
switch lever and raise the height of cut. Failure to
do so could damage the machine.

Maintenance

Stop, remove plug from the power supply
and remove the grassbox.
Note: To ensure long and reliable service, carry out
the following maintenance regularly.
Regularly check for obvious defects such as loose,
dislodged or damaged blades, loose fixings, and
worn or damaged components.
Check that covers and guards are undamaged and
correctly fitted. Carry out necessary maintenance or
repairs before using.
If the mower should happen to fail despite the care
taken in manufacture and testing, repair should be
carried out by an authorised customer service agent
for Bosch garden products.
For all correspondence and spare parts orders, al-
ways include the 10-digit part number from the
nameplate of the machine!
Adjusting the Blade
G
Stop, remove plug from the power supply
and remove the grassbox.
The cutting cylinder should be adjusted if the grass
is not cut cleanly and evenly.
Turn the machine upside down.
Using a screwdriver turn both the adjuster screws 12
clockwise a little at a time until the cutting cylinder 13
lightly brushes the bottom blade 14.
Note: The blades act like a pair of shears.
English - 3