Maintenance - Bosch ARM 320 Bedienungsanleitung

EURO • Printed in England • BA F 016 L69 797 • ARM 320 • GB • OSW 11/00
F 016 L69 797.book Seite 4 Dienstag, 21. November 2000 7:52 07
Starting and Stopping (Figure D)
To aid starting push handle down to lift front
wheels.
Starting:
Press and hold the safety button 2.
Squeeze the switch lever 1 towards the han-
0
dle.
2
1 Release the safety button 2.
I
Stopping:
Release the switch lever 1.
Mowing
Place the lawnmower on the edge of the lawn, as
close to the power point as possible. Work away
from the power point as in figure F. Then at right an-
gles.
Position the cable to opposite side (already cut) at
the end of each turn.
When mowing do not allow the motor to la-
bour particularly in heavy conditions.
When the motor labours the speed of the mo-
tor drops and you will hear a change in the mo-
tor sound, when this occurs stop mowing, re-
lease switch lever and raise the height of
cut. Failure to do so could damage the ma-
chine.

Maintenance

Stop, remove plug from the power supply
and remove the grassbox.
Note: To ensure long and reliable service, carry out
the following maintenance regularly.
Regularly check for obvious defects such as loose,
dislodged or damaged blades, loose fixings, and
worn or damaged components.
Check that covers and guards are undamaged and
correctly fitted. Carry out necessary maintenance or
repairs before using.
If the mower should happen to fail despite the care
taken in manufacture and testing, repair should be
carried out by an authorised customer service agent
for Bosch garden products.
For all correspondence and spare parts orders, al-
ways include the 10-digit part number from the
nameplate of the machine!
F016 L69 797 • 11.00
Blade Maintenance (Figure G)
Stop, remove plug from the power supply
and remove the grassbox.
Turn the machine on its right side and inspect the
blade and fan; if blunt or damaged, replace.
Use the following procedure to remove and replace
the blade.
Hold the blade 14 using gardening gloves (not pro-
vided) use a spanner (not provided) to remove the
blade nut 13 and blade.
Before fitting the new blade, ensure that the fan 15 is
fitted correctly on the shaft. It will fit in only one posi-
tion.
Fit the blade and the blade nut. Ensure that the blade
is the correct way up (so that this
seen located as in figure G) and tighten the nut
firmly.
After Mowing/Storage
Clean the exterior of the machine thoroughly using a
soft brush and cloth. Do not use water, solvents or
polishes. Remove all grass and debris, especially
from the ventilation slots 9.
Turn the machine on its right side and clean the
blade area. If grass cuttings are compacted in the
blade area, remove with a wooden or plastic imple-
men.
Store the machine in a dry place. Do not place other
objects on top of the machine.
To aid storage loosen the wing nuts 12 and fold the
handles.
Ensure cables are not trapped when folding/
unfolding top handles, do not drop the han-
dles.
English - 4
symbol can be