Fault Finding; Environmental Protection - Bosch ASM 32 F Bedienungsanleitung

WMV-Dresden, Ersatzteilservice für Elektrowerkzeuge, Motor- und Gartengeräte
EURO • Printed in England • BA F 016 L69 883 • ASM 32/32 F • GB • OSW 02/01
F016 L69 883.book Seite 4 Dienstag, 15. Januar 2002 8:38 08
After Mowing/Storage
Clean the exterior of the machine thoroughly using a
soft brush and cloth. Do not use water, solvents or
polishes. Remove all grass and debris, especially
from the ventilation slots 9.

Fault Finding

The following table gives checks and actions that you can perform if your machine does not operate cor-
rectly. If these do not identify/remedy the problem, contact your service agent.
Warning: Switch off and remove plug from mains before investigating fault.
Symptom
Machine fails to operate
Machine functions
intermittently
Machine labours or belt
squeals
Machine leaves ragged
finish
Cutting blades not rotat-
ing
Excessive vibration/noise Cutting blades damaged
Poor collection
Guarantee
We guarantee Bosch appliances in accordance with
statutory/country-specific regulations (proof of pur-
chase by invoice or delivery note).
Damage attributable to normal wear and tear, over-
load or improper handling will be excluded from the
guarantee.
In case of complaint please send the machine, un-
dismantled, to your dealer or the Bosch Service
Centre for lawn and garden products.
14 • F016 L69 883 • 02.01
Turn the machine on its side and clean the blade
area. If grass cuttings are compacted in the blade
area, remove with a wooden or plastic implement.
H
place other objects on top of the machine. To save
space, fold up the handle fully.
Possible Cause
Power turned off
Mains socket faulty
Extension cable damaged
Fuse faulty/blown
Extension cable damaged
Machines internal wiring damaged
Height of cut too low
Blades off cut
Cutting blade(s) blunt
Blades off cut
Cutting blades obstructed
Belt is slipping or is damaged
Cutting blades not adjusted evenly
Mowing in wet conditions

Environmental Protection

English - 4
Store the lawnmower in a dry place. Do not
Ensure cables are not trapped when fold-
ing/unfolding top handles, do not drop the
handles.
Remedy
Turn power on
Use another socket
Inspect cable, replace if damaged
Replace fuse
Inspect cable, replace if damaged
Contact Service Agent
Increase height of cut (see "Height of
Cut Adjustment")
Adjust blades
Contact Service Agent
Adjust blades
Clear obstruction
Contact Service Agent
Contact Service Agent
Adjust blades
Allow grass to dry
The machine has been assembled in
an environmentally responsible way.
Recycle raw materials instead of
disposing as waste.
Machine, accessories and packaging
should be sorted for environment-
friendly recycling.