Installation; Electrical Connection; Water Connection - Kärcher HD 5/12 C Handbuch

Nozzle storage for triple nozzle
5
Transport retainer for surface cleaner
6
Push handle lock
7
Push handle, bottom (pushed in)
8
Push handle, top (pulled out)
9
High-pressure nozzle
10
High-pressure nozzle marking
11
EASY!Lock spray lance
12
EASY!Force high-pressure gun
13
Safety latch
14
Trigger
15
Safety lever
16
EASY!Lock high-pressure hose
17
Hose storage compartment
18
Cable clips
19
Spray lance holder without a clamp
20
Rubber band (not in devices with a hose reel)
21
Nozzle storage compartment for rotary nozzle (rota-
22
ry nozzle only included in the scope of delivery of
the "Plus" variant)
Spray lance holder with a clamp for transport
23
Power switch
24
Handle
25
EASY!Lock high-pressure connection
26
Handle
27

Water connection

28
Detergent suction hose with filter and detergent
29
dosing unit
sieve
30
Hose spout
31
Union nut
32
Crank
33
Hose reel
34
Colour coding
 Control elements for the cleaning process are yel-
low.
 Control elements for maintenance and servicing are
light grey.

Installation

Fastening the hubcaps
 Fasten the hubcaps.
Installing accessories
Note
The EASY!Lock system connects components quickly
and safely via a single turn of the quick-release thread.
1. Fit the high-pressure nozzle onto the spray lance
with the marking facing upwards.
2. Tighten the high-pressure nozzle hand-tight
(EASY!Lock).
3. Connect the spray lance to the high-pressure gun
and hand-tighten (EASY!Lock).
1.
4. Release the push handle lock.
5. Pull the push handle out to the end position.
For devices without a hose reel:
6. Connect the high-pressure hose to the high-pres-
sure gun and high-pressure connection of the de-
vice and tighten hand-tight (EASY!Lock).
For devices with a hose reel:
7. Lay the high-pressure hose on the ground in a
straight line.
8. Insert the crank into the hose reel shaft and latch
into position.
9. Turn the crank clockwise and wind the high-pres-
sure hose onto the hose reel in evenly distributed
layers.
10. Connect the high-pressure hose to the high-pres-
sure gun and hand-tighten (EASY!Lock).

Electrical connection

DANGER
Failure to disconnect the mains
Risk of injury from electric shock
Use a plug to connect the device to the mains grid. Per-
manent connection to the mains grid is prohibited. The
plug is used for disconnection from the mains.
1. Unwind the mains cable and place on the ground.
2. Plug the mains plug into the socket.
Water connection
Connection to a water line
WARNING
Return flow of dirty water into the drinking water
network
Health risk
Observe the regulations of your water supply company.
According to applicable regulations, the device must
never be used with the drinking water network without a
system separator. Use a system separator from
KÄRCHER or a system separator as per EN 12729
Type BA. Water that has flowed through a system sep-
arator is classified as undrinkable. Always connect the
system separator to the water supply and never directly
to the water connection on the device.
1. Check the supply pressure, supply temperature and
supply volume of the water supply (see chapter
Technical data).
2. Connect the system separator to the water connec-
tion of the device using a water supply hose (for the
requirements placed on the water supply hose see
chapter Technical data).
3. Open the water inlet.
English
2.
13