Assembly; Assembling The Curved Handle; Installing The Grass Catcher; Operation - Grizzly ERM 1844 G Originalbetriebsanleitung

GB

Assembly

Disconnect the plug before any
work on the equipment. There is a
risk of injury.

Assembling the Curved Handle

Install lower bar:

Insert the bottom bars (4) into
the brackets provided for this on
the right and left of the equip-
ment casing.
‚
Screw them in place with one
cross-head screw (6) in each.
Install curved handle:

Use the screws and washers from
the package as well as the top
clamping levers (3) to mount the
curved handle (1) on the right and
left ends of the bottom bar (4).
Two positions are possible.
‚
Turn the clamping levers (3)
clockwise.
ƒ
Lock the clamping levers (3) by
pushing them towards the bar (4).
Clamping levers to be tightened
and contacting the bar such that
they clamp at average force.
Otherwise you may have to
tighten (turn clockwise) or loos-
en them (turn anticlockwise).
Clip on the cable hook:
Clip on the cable hooks (
13) to the bar to fasten the
connection cable (

Installing the grass catcher

Assemble the grass catcher:

Clip the rubber lip of the grass
26

Operation

Mounting / removing the grass
catcher
15).
catcher net (19) into the hard
plastic tray of the grass catcher
(7).
‚
Insert the linkage tubes (19) into
the grass catcher net (20). Make
sure to fully insert the tubes (see
ill. detail).
The tube bows fit into the
groove (21) at the bottom of the
grass catcher.
ƒ
Pull the plastic straps (22) over
the linkage tubes (20).
„
Use the screws and washers
(23) from the package to mount
the linkage tubes (20).
Attention: Do not operate the ap-
pliance until the collision guard
and grass catcher are fully in-
stalled. Risk of injury!
1. Lift the collision guard (5).
2. Place the grass catcher (7) on the
mounting bracket (24) provided at
the back of the lawn mower.
3. Lower the collision guard (5)
onto the grass catcher (7) - it
will keep it in place.
4. To remove the grass catcher (7),
lift the collision guard (5) and un-
hook the grass catcher from the
mounting bracket. Flap down the
collision guard to the housing.
On emptying the grass catcher
also refer to section "Disposal/
environment".