Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
Assembly
Disconnect the plug before any
work on the equipment. There is a
risk of injury.
Mount the front wheel
1. Insert the two screws from the
inside through the recesses on
the front sheet steel housing (6).
2. Fix the front wheel (5) with the
two washers and nuts.
3. Attach the front wheel (5) to the
top of the lawnmower housing
(6) with the nuts and bolts.
Installing the Handle Bar
For a simple holmm installation,
select cutting height 25 mm (see
„Adjusting the cutting height").
1. Slide the two ends of the lower
handle bar (3) into the receptor
on the mower housing.
2. Fix the lower bar using the sup-
plied wing screws (7).
D
3. Fasten the upper handle bar (1)
using the tensioning levers (13).
When both tensioning levers (13)
are loosened, the curved handle
can be folded down for storing the
equipment. Ensure that the power
cable is not caught.
Install/empty grass catchment
basket
Caution: Do not operate the
equipment with the grass col-
lection box or impact protection
28
All manuals and user guides at all-guides.com
installed incompletely. Risk of
injury!
Assemble grass catchment
basket:
1. Pull plastic loops (21) over bas-
ket rods (20).
Fixing the Grass Collection
Box onto the Equipment:
2. Lift up shock protection (4).
3. Hook the grass collection box
(10) into the mounting provided
for this on the rear of the equip-
ment. .
4. Release the impact protection
(4). It holds the grass collection
box in position.
Dismantling/Empty out the
Grass Collection Box:
5. Lift the impact protection (4) and
remove the grass collection box
(10).
6. Empty catchment basket (see
chapter „Disposal / Environmen-
tal Protection") and re-install it.
Operation
Level gauge
The level gauge (12) is located on the
side of the grass catcher (10).
Flap (12) open:
grass catcher (10) empty
Flap (12) closed:
grass catcher (10) full
The level indicator (12) works
when the device is in operation.
Werbung
Inhaltsverzeichnis
Fehlerbehebung
