Activating And Setting The Date/Time; Attaching The Cuff - uebe visocor HM50 Gebrauchsanweisung

Operating the unit
C
• Close the battery compartment by clipping the
battery cover back into the device.
When the "empty battery " symbol first appears
in the display, you are still able to take around 30
measurements. Please replace the batteries within
this time frame.

6. Activating and setting the date/time

Activating and deactivating the date/time function
To activate the date/time function, press the Start/Stop button
and then immediately, while the full display is visible, the Mem-
ory button. This function can be deactivated at any time in the
same way.
Setting the date/time
The four-digit number representing the year ap-
pears in the display first (Figure 1). Press the Mem-
ory button to set the year. Press the Start/Stop but-
EN-50
ton to confirm the selected year and
proceed to setting the date (Figure 2).
Set the month with the Memory but-
ton and confirm this with the Start/
Stop button. Set the day, hours and
minutes in the same way (Figure 2,
Figure 3).
Changing the date/time
To change the date and time, take the batteries out and wait until
the display goes off. Then re-insert the batteries and reset the
date and time.
After replacing the batteries, you will have to reset the date and
time.

7. Attaching the cuff

The special double-preformed comfort cuff is easy to attach and
ensures a perfect fit during measurement. The materials used are
tested for skin compatibility according to ISO 10993.
Figure 1
Operating the unit
C
Figure 2 Figure 3
EN-51