TermaTech TT22 Montage- Und Bedienungsanleitung Seite 60

Read these instructions carefully before installing your new wood-burning stove. Also read the provided installation and user instruc-
tions for the TT22 stove series.
Note: The size of the stones may vary slightly, making it necessary to adjust the various parts.
The stones are a natural material, so there will be differences in colours and patterning.
1: Start by positioning the
stove in the desired location
in the home. If it has been
decided to use a shaped floor
plate, remember to mount the
provided adjustable feet under
the stove (stored in the ash
drawer or fuel compartment).
5: Bottom stone
Fit the angle irons provided inside the fuel compartment. Mount and adjust the angles so that the stones are in place and are flush with
the edges of the stove.
6: Top front stone
The stone has three threaded
holes for the provided bolts and
washers.
9: Side stones
To mount these, you will need a 10mm socket spanner mounted
on an extension bar. To fix the stones, use the provided fittings
with metal pin and 10 mm bolt and washer.
You will be able to adjust the stones outwards.
Make sure they are equal distances from the sides of the stove.
2
60
Installation instructions TT22HST
Mounting the soapstone panels
2: Unpack the stones. The
photo below shows the stone
parts included (take care, as
edges and corners can easily be
damaged).
7: Place the stone against the
metal plate with the threaded
holes in line with the prepared
holes, and fix it in place with a
10 mm socket spanner.
3: The two front stones are
identical, so it does not matter
which stone goes at the bottom
or top.
8: Heat retention stones
Position the 4 heat retention
stones as shown here.
10: Top stone
The top stone should be loosely
placed on the top, with the
prepared holes matching the
mounted threaded studs with
fitted bolts.
UK
4: For mounting, use a 10mm
socket spanner.