Maintenance - Makita 1911B Betriebsanleitung

Sharpening the planer blades (Fig. 12, 13 & 14)
Always keep your blades sharp for the best perfor-
mance possible. Use the sharpening holder to
remove nicks and produce a fine edge.
First, loosen the two wing nuts on the holder and
insert the blades (A) and (B), so that they contact the
sides (C) and (D). Then tighten the wing nuts.
Immerse the dressing stone in water for 2 or
3 minutes before sharpening. Hold the holder so that
the blades both contact the dressing stone for simul-
taneous sharpening at the same angle.
Connecting a vacuum cleaner
For European countries and areas only
(Fig. 15 & 16)
When you wish to perform clean planing operation,
connect a Makita vacuum cleaner to your tool. Install
the nozzle assembly (standard equipment) on the
tool using the screws provided. Then connect a hose
of the vacuum cleaner to the nozzle assembly as
shown in Fig. 16.
8

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
To maintain product safety and reliability, repairs,
maintenance or adjustment should be carried out by
a Makita Authorized Service Center.