Bosch SensorSteam TDS12-Serie Gebrauchsanleitung Seite 15

Trouble shooting guide for minor issues
Problem
The iron does not heat up.
"ActiveControl Advanced"
indicator lamp (3) lashes.
Iron dificult to slide on the
The clothes tend to stick.
Water drips out of the
soleplate together with
steam.
Spray does not work.
Smoke comes out when
connecting the iron for the
irst time.
You can download this manual from the local homepages of Bosch.
Probable cause
1. Temperature control (15) set to
minimum.
2. No mains supply.
3. The "SensorSteam" system has been
activated. The iron is set to stand-by.
The temperature is too high.
1. Temperature control (15) setting is
too low.
2. Steam control is set too high in
conjunction with a low temperature.
3. You have pressed the shot of steam
button (6) repeatedly without waiting
for 5 seconds between each press.
4. Pure distilled water has been used
(see "Filling the water tank" section)
or other products such as fragrant
water have been added to the tank.
2. No water in the tank (11).
3. The temperature is too low. Anti-drip
system is activated.
1. No water in the tank (11).
2. Obstructed mechanism.
1. Turn to a higher position.
2. Check with another appliance or plug the
iron into a different socket.
3. Grip the handle (1) of the iron to re-start
it.
" settings.
he temperature control (15) down and Turn t
wait until the iron has cooled down.
1. Turn the temperature control (15) to a
higher setting (between "••" and "max")
and wait until the green steam setting
indicator lamp stops lashing.
1. Set the steam control to "eco" or "max"
" position.
position.
2. Fill the tank (11).
3. Set to a higher temperature if compatible
with the fabric.
1. Fill the water tank (11).
2. Contact the Technical Service.
en
Solution
15