Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
_________________________________________________________________________________________
5
Servicing, cleaning, maintenance
No special maintenance required, the spindle and the internal vice components have been
protected by the carriage and central jaw design. Regularly grease carriage contact surfaces
e.g. with MOTOREX Supergliss 68 K to ISO VG 68
We recommend cleaning the double vice when replacing jaws as these components are
fast and easy to remove.
Regularly clean the vice through the two cleaning bores on the face of the
front carriage using a compressed-air gun to prevent deposits of small chips and swarf.
5.1 General cleaning / lubrication
Lubricate the lubrication nipples (pos. 200) on both carriages using multi-purpose grease once
a month. For this purpose, turn the carriages towards the far inside.
If you have applied excessive amounts of grease, it may be possible that the closing disc
(pos. 170) in the carriage (pos. 60) is pressed out.
schunk.com
.
XND.00033.002_A – 10/2018
,
33
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
