Operator Duties; Operator Qualification; Personal Protective Equipment; Warranty - SCHUNK KSC-D 125 Montage- Und Betriebsanleitung

_________________________________________________________________________________________

2.5 Operator duties

All persons who have been instructed to work with the machine undertake to:
 observe the basic regulations for health and safety and for the prevention of accidents.
 read and understand the section on safety and the safety instructions in these operating
instructions prior to working with the machine, and to observe these instructions.

2.6 Operator qualification

The installation, initial setup, fault analysis and periodic monitoring have to be carried out by
competent personnel with the relevant qualifications.

2.7 Personal protective equipment

2.8 Warranty

The warranty period is 24 months from the date of delivery; the warranty applies subject to
being used as intended and to the following conditions:
 Compliance with concurrent documents.
 Compliance with environmental and operating conditions.
 Compliance with the specified maintenance and lubrication intervals.
 Observance of the maximum service life.
Any parts in contact with workpieces and wear parts are not covered by the warranty.
Warranty – maximum service life
Warranty period
Maximum service life [clamping cycles]
schunk.com
Risk of eye injury through ejected, hot fragments!
Ejected hot fragments can lead to serious eye injury.
The regulations for safety at work and the prevention of
accidents always have to be observed when working with the
machine.
Personal protection equipment must be worn at all times,
in particular safety boots, gloves and safety goggles.
WARNING
24 months
50,000
XND.00033.002_A – 10/2018 27