Assembly - SCHUNK KSC-D 125 Montage- Und Betriebsanleitung

_________________________________________________________________________________________
8

Assembly

Installing the carriage unit
 Fully contract the carriage unit.
 Push the carriage unit into the guide until it comes into contact with the other component.
The carriage unit is now positioned around 20 mm over the centre. Important: carriage
unit must not come into contact with the rear cylinder screw. (pos. 160)
 Fully tighten the clamping screw (pos. 230) and undo by ½ turn.
 Extend the carriage unit and check whether or not the cylinder screw (pos. 40) and the
clamping screw (pos. 230) have correctly engaged in the clamping piece. (pos. 220).
 Install the front cylinder screw. (pos. 160)
 Install the system jaws.
schunk.com XND.00033.002_A – 10/2018 35