Werbung
Verfügbare Sprachen
Verfügbare Sprachen
RN42236MEE Rev1_9225 47507 MEE pump - Jon 27/08/2010 16:07 Page 7
g
Contents
Getting the best from your new ironing
system....
Safety first
Caution must be used when handling this appliance as it
does get very hot. Always switch off the unit and allow to
cool before cleaning or storing.
Water tank
The fixed water tank can be re-filled at any time during
ironing.
Performance
To extend the performance and life of your IntelliDome
generator, ensure that you replace the anti-scale filter
according to the on-board indicator. Regularly remove any
calcium build-up which may have accumulated in the boiler
(see cleaning instructions).
To improve the life of your new product and to ensure the
cleanliness of your clothes, we strongly recommend the
use of distilled or demineralised water.
QUICK START GUIDE
1
Unpack the product and remove any additional packing
materials as required.
2
Place the product onto a level surface or ironing board
stand.
3
Make sure the anti-scale drawer ‰ is fully closed.
4
Using the beaker provided Á or suitable measuring jug, fill
the water tank fl to the full mark.
5
Set the iron control knob to 3-dot.
7
6
Connect the unit to the power supply, the LCD display screen
illuminates for 1 second, a short beep is heard, then the LCD
7
display screen will turn off. The product is now in standby
8
mode and the standby ICON will be displayed in the corner of
the LCD display screen A.
8
7
Press the POWER standby button on the control panel and
9
the unit will heat to the working temperature, the low steam
ICON will flash whilst the heating cycle takes place and will
9
remain illuminated when the boiler is ready to deliver steam
9
B.
Note: At this time, the pump will fill the boiler with water. You
10
will hear the pump operating, this is quite normal and will last
10
for approximately 25 seconds.
10
8
Press the steam trigger ⁄ to deliver steam to the iron.
Releasing the trigger will extinguish steam.
11
9
When ironing is complete, press the POWER STANDBY
11
button on the control panel to end the session. The LCD
icons will dim until the unit is disconnected from the mains
11
supply, only then will the LCD switch off.
11
10 Allow the unit to cool, drain the water tank (see Water
12
management section), then store away.
12
AUTO STANDBY DEVICE
12
If the unit is not operated for approximately 15 minutes, it will
revert to STANDBY mode and the POWER STANDBY ICON
will flash in the LCD display screen C. To re-activate the unit,
press the POWER STANDBY button or the steam trigger ⁄
and the unit will revert back to the previous setting.
IMPORTANT SAFETY INSTRUCTIONS
The use of any electrical appliance requires the use of
common sense and strict following of safety rules.
Primarily there is danger of injury or death and secondly the
danger of damage to the appliance. These are indicated in the
text by the following two conventions:
WARNING: Danger to the person!
IMPORTANT: Damage to the appliance!
In addition, we offer the following safety advice.
Location
•
Do not use outdoors.
•
Locate the steam generator horizontally on the rest plate of
your ironing board (if large enough) or on a heat resistant
stand at the same height as your ironing board or below it.
Always ensure the generator is on a firm level surface when
ironing.
•
IMPORTANT: Do not use the product on a surface which
could be damaged by heat or steam such as a worktop or a
polished wood surface.
•
If in doubt, contact Morphy Richards.
g
(Safety feature)
7
Werbung
Kapitel
