Inserting The Bobbin - ELNA eXperience 660 Gebrauchsanleitung

Inserting the Bobbin

Place the bobbin in the bobbin case with the thread
running counterclockwise.
Guide the thread into notch on the front side of the
A
bobbin case.
Hold the bobbin with your right hand and pull the thread
to the left, through the tension spring blades.
A
Continue pulling the thread lightly until the thread slips
into notch .
B
Pull out about 15 cm (6˝) of thread.
B
Replace the bobbin cover plate.
Refer to the chart shown on the bobbin cover plate to
check the threading.
24