Using A Subwoofer - JVC KD-LX50R Bedienungsanleitung

Using a subwoofer

By connecting a subwoofer to the SUBWOOFER OUT plugs on the rear, you can enjoy
enhanced bass sounds and a more realistic theater atmosphere in your car.
• Refer also to the instructions supplied with your subwoofer.
To set the subwoofer cutoff frequency, follow the procedure below.
When a subwoofer is connected to this unit, select an appropriate cutoff frequency level for your
subwoofer. When shipped from the factory, the subwoofer cutoff frequency is set to "MID."
• FREQ LOW: Frequencies higher than 50 Hz are cut off to the subwoofer.
• FREQ MID: Frequencies higher than 80 Hz are cut off to the subwoofer.
• FREQ HIGH: Frequencies higher than 120 Hz are cut off to the subwoofer.
1 Press and hold SEL (Select) for more than 2 seconds so that one of the PSM items
appears on the display.
¢ or 4
2 Press
3 Press + or – to select the desired cutoff frequency.
4 Press SEL again to finish the setting.
To adjust the subwoofer output volume, see "Adjusting the sound" on page 25.
repeatedly until "WOOFER FREQ" appears on the display.
69