AEG GS60BISM Benutzerinformation Seite 11

German de- French degrees
grees (°dH)
<4
1) Factory setting.
2) Do not use salt at this level.
Whether you use a standard detergent
or multi-tabs (with or without salt), set
the proper water hardness level to
keep the salt refill notification active.
Multi-tabs containing salt
are not effective enough to
soften hard water.
How to set the water softener
level
Make sure the appliance is in user mode.
1. Press Program.
• The indicators
are off.
• The indicator
• The display shows the current
setting: e.g.
2. Press Program repeatedly to change
the setting.
3. Press on/off to confirm the setting.
6.3 The rinse aid empty
notification
The rinse aid helps to dry the dishes
without streaks and stains. It is
automatically released during the hot
rinse phase.
When the rinse aid chamber is empty,
the rinse aid indicator is turned on
notifying to refill rinse aid. If the drying
results are satisfactory while using multi-
tablets only, it is possible to deactivate
the notification for refilling rinse aid.
However, for best drying performance,
always use rinse aid.
If standard detergent or multi-tablets
without rinse aid are used, activate the
notification to keep the rinse aid refill
indicator active.
mmol/l
(°fH)
<7 <0.7
, and
still flashes.
= level 5.
Clarke de-
grees
< 5
How to deactivate the rinse
aid empty notification
Make sure the appliance is in user mode.
1. Press Start.
• The indicators
are off.
• The indicator
flashes.
• The display shows the current
setting.
– = the rinse aid empty
notification is deactivated.
– = the rinse aid empty
notification is activated.
2. Press Start to change the setting.
3. Press on/off to confirm the setting.
6.4 The rinse aid level
It is possible to set the released quantity
of rinse aid between level 1 (minimum
quantity) and level 6 (maximum quantity).
Level 0 deactivates the rinse aid
dispenser and no rinse aid is released.
Factory setting: level 4.
How to set the rinse aid level
Make sure the appliance is in user mode.
1. Press Delay.
• The indicators
and
• The indicator
• The display shows the current
setting: e.g.
– The levels of rinse aid range
from 0A to 6A where level 0A
means no rinse aid is used.
2. Press Delay repeatedly to change
the setting.
3. Press on/off to confirm the setting.
ENGLISH 11
Water softener lev-
el
2)
1
, and
still
,
are off.
still flashes.
= level 4.