Cleaning And Care; Descaling - Unold 8250 Bedienungsanleitung

5. Close the lid until it clicks into
place. The locking prevents acci-
dental opening.
6. Place the kettle level on the base
in order to establish the contact
with the power connection.
7. Switch on the kettle by pressing
the ON/OFF switch downwards
into the „I"-position. The kettle
cannot be switched on if it is not
properly seated on the base.
8. Whenever you take the kettle off
the base, the appliance is auto-
matically switched off, even if the
water is not yet boiling.
9. The kettle automatically stops
heating at the latest when the
water boils.
10. ATTENTION:
The automatic switch-off only
works, if the lid is correctly closed.
11. Of course you may also push the
switch into the „O"-position to
interrupt heating.
12. CAUTION!
Ensure that the kettle is switched
off before removing it from the
base.

CLEANING AND CARE

Before cleaning, always turn
off the appliance and unplug it
from the power supply.
Allow the appliance to cool
before cleaning it.
1. Do not immerse the base, power
cord or kettle in water or other
liquids or wash them in the dish-
washer.

DESCALING

1. To keep the appliance operating
efficiently and to prolong its ser-
vice life, it should be descaled
regularly, depending on the hard-
ness of your water.
2. The lime scale filter has to be
cleaned regularly. Please empty
16
13. Please allow the product to cool
down for a certain time before
using the kettle again to heat
water.
14. The kettle is fitted with a dry-
operation cutout that switches off
the heating elements when they
become too hot, for instance when
the kettle has boiled dry. Allow
the kettle to cool down. Then fill
the kettle with cold water. This
will reset the cutout so that the
kettle can be used again.
15. Always use fresh and cold water.
Do not leave water in the kettle.
16. Switch off and unplug electrical
appliances after use.
Boiling
scalding. Therefore, please
handle the appliance with care
when it contains hot water.
The appliance becomes very
hot during
maintains the heat during
some time after disconnection.
2. Wipe off the base and the kettle
with a damp cloth and a little
dishwashing detergent. Do not
use any abrasive scouring agents,
steel wool, metal objects, hot
cleaning agents or disinfectants,
since they can damage the appli-
ance.
3. The appliance must be comple-
tely dry on the outside before you
use it again.
the kettle completely and allow it
to cool off. Carefully remove the
filter from the pour spout. Clean
the filter carefully with a soft
brush under running water. You
can also place the filter in a bowl
with a descaling solution. Then
water can cause
operation and