Before First Use; Manual Mode; Automode And Program - Klarstein 10027868 Anschluss- Und Anwendungshinweise

• Carefully unpack the blender and accessories, and remove all packaging materials.
• Wash the blender according to the Cleaning Your Blender section of this manual.
1 Put ingredients in jar. Always add liquid ingredients fi rst followed by solid ingredients.
2 Place the fi ller cap insert into the blender lid opening and turn fi ller cap clockwise until tight. Firmly
attach assembled lid to the blender jar.
3 Plug the blender into a 220-volt 60 Hz AC-only outlet. Place the blender jar on the motor base.
All icons will display briefl y for 1 second and the blender will be in stand-by mode. The timer will
display "00:00".
4 The timer display shows elapsed time.
5 This blender has 10 speeds plus a Pulse function. Select the speed that best suits your blending
task. We recommend always starting on Low speed and gradually increase to your desired speed.
The speed range low to high can be set by sliding your fi nger from the lowest speed bar to the
highest. The speed can also be adjusted when the blender is operating.
6 When the SPEED has been set, touch the START/CANCEL icon to start blending. The color of the
icon will change from red to white. To turn off the blender, touch the START/CANCEL icon while
blending. The blender will turn off and the START/CANCEL icon will change back to a red color.
7 To add ingredients while the blender is on, remove the fi ller cap insert and drop ingredients
through the lid opening. Replace the fi ller cap securely when done. Do not place your hands into
the blender jar with the blender plugged in.
8 The blender can also be used in PULSE mode without setting the SPEED. To use the PULSE mode,
touch the PULSE icon once to activate the PULSE mode (the light will be blinking). Touch and hold
the PULSE icon within 5 seconds to start blending in PULSE mode. To stop the PULSE mode, simply
release the PULSE icon. The blender always operates on the highest speed in PULSE mode regard-
less of the preset program selected. When using the PULSE mode, the light will illuminate white
and the display will show a time of 88:88.
9 When blending hot liquids ensure the lid is securely in place. Place the fi ller cap into lid and turn
clockwise until is stops (about a quarter turn), Always start in low speed and then increase speed
to desired setting.
WARNING
Use caution with hot liquids. Spraying from under the fi ller cap can occur, or escaping steam
may cause scalding. Only use the lid provided with your blender.
Your blender has 6 preprogrammed modes that automatically set the speed and blending cycle. See
reference chart below. Follow the below instructions to use automatic mode.
• Put ingredients in the Blender Jar. Always add liquid ingredients fi rst followed by solid ingredients
unless a recipe states otherwise.
• Place the fi ller cap insert into the blender lid opening and turn fi ller cap clockwise until tight. Firmly
attach assembled lid to the blender jar.
• Plug the blender into a outlet. Place the blender jar on the motor base. All icons will display briefl y
for 1 second and the blender will be in stand-by mode. The timer will display "00:00".
• Select the desired preset program selection then touch the START/CANCEL icon. The blender will
run in the mode according to the selected program. To stop the blender at any time during opera-
tion, touch the START/CANCEL icon and the blender will go back to standby mode.
Before fi rst Use

Manual Mode

Automode and Program

14