Use And Operation - Klarstein 10028901 Handbuch

Use and Operation

Extracting
Fill ingredients into the Tall or Short
Cup, add the liquid of your choice up
to the MAX line (Liquid is required!).
Twist the Extractor Blade onto the
Tall Cup and hand tighten to make
sure the vessel has been sealed.
Press the vessel blade side-down
onto the Power Base. Press down
and twist to extract for no longer
than 2 minute, then must stop wor-
king 5 minute before you continue
using, after using 3 cycles, set aside
for a while to cool down.
To turn off the UNIT - simply twist in the opposite direction (to the right) to release the tabs and stop pressing
down on the cup. Once the power base stops completely, remove the cup from the power base.
Milling
The Milling Blade is for turning dry ingredients into powders. Perfect for milling oats, nuts and seeds.
Fill ingredients into the Short Cup.
Twist on the Milling Blade. Place
the Cup onto the Power Base. Press
down and twist to lock the motor on,
and then mill your ingredients until
you achieve the desired consistency.
To turn off the UNIT - simply twist in
the opposite direction (to the right)
to release the tabs and stop pressing
down on the cup. Once the power
base stops completely, remove the
cup from the power base.
10