Helpful Hints; Cleaning And Care - Klarstein 10027868 Anschluss- Und Anwendungshinweise

• If you need to scrape ingredients from the sides of the jar ensure your blender is off unplug from
the wall outlet.
• When blending solid foods, always cut them into no larger than 1/2-inch to 1-inch pieces before
placing them into the jar. Blend no more than 1/2 cup of these foods at a time for uniform blending.
• We do not recommend blending herbs or spices in the blender jar. They can permanently discolor
the blender jar and release strong odors into the container which will affect the fl avor of other
foods.
• Remember that ice cubes vary in size and shape. Smaller ice cubes can be chopped or crushed
faster than larger ones. To add ice cubes to mixtures while the blender is operating, remove the
fi ller cap and drop through the opening.
• If too much food is blended at one time, the motor may stall. If this happens, stop the blender and
unplug from the wall outlet. Remove a portion of the food and then continue the blending process.
• For more consistent results, always add liquid ingredients fi rst, followed by solid ingredients.
• To add food or liquid while the blender is operating, remove the fi ller cap from the blender jar cover
and drop the ingredients through the opening. Remember to replace the fi ller cap when fi nished
adding ingredients. Avoid over-blending. Usually, you will need to blend for only a few seconds,
not minutes.
ATTENTION
Risk of burns! DO NOT remove the fi ller cap or lid if blending hot liquids to avoid a potential
burn injury
• This blender is NOT intended to grind meat, mash potatoes, knead dough, whip egg whites, or
serve as a juice extractor.
• Never place any of the following ingredients into the blender jar: bones or large pieces of solidly
frozen foods. If a food cannot be cut with a knife, do not place it in the blender jar.
• When making peanut butters or other nut butters or oil based foods do not process for more than
1 minute. Over-processing can cause overheating.
• Your blender motor is equipped with a overheat protection system. Should the motor overheat it
will turn itself off. If your blender should overheat unplug from the wall outlet and let it cool down
for 45 minutes.
1 Unplug your blender and ensure that all parts have completely cooled.
2 Do not place your any parts of your blender or tamper in the dishwasher.
3 Remove jar from motor base by lifting straight up. Rinse with warm water to remove any large food
particles that may have accumulated in the jar. Extreme caution should be used when cleaning
your blender jar as the blades are very sharp.
4 Your blender jar can be cleaned by adding a few drops of dishwashing detergent into the blender
jar and fi lling with 2 cups of warm water. Place the cover with fi ller cap on the jar and press the
SMOOTHIE icon followed by the START/CANCEL icon. Rinse and repeat with clean tap water as
necessary.
5 Wash the fi ller cap and lid in warm soapy water and dry thoroughly.
6 Wash the tamper stem with a damp soapy cloth and rinse. Do not immerse the top of the tamper
in water or any other liquid, nor place under running water. Dry thoroughly.
7 Wipe the cord and base clean with a damp cloth. Dry thoroughly.
8 Caution: Do not immerse the plug, cord, or blender motor base in water or other liquid. Do not use
abrasive cleansers on any part of the blender.
IMPORTANT: Refer all servicing to qualifi ed personnel. Therefore, do not attempt to service the
device yourself. If you are unable solve a problem, please contact our Customer Service.

Helpful Hints

Cleaning and Care

16