Cleaning The Spray Arms; External Cleaning; Internal Cleaning; Troubleshooting - AEG GS60BISW Benutzerinformation

16 www.aeg.com
5. Make sure that there are no residues
of food or soil in or around the edge
of the sump.
6. Put back in place the flat filter (A).
Make sure that it is correctly
positioned under the 2 guides.
7. Reassemble the filters (B) and (C).
8. Put back the filter (B) in the flat filter
(A). Turn it clockwise until it locks.

12. TROUBLESHOOTING

If the appliance does not start or it stops
during operation. Before you contact an
Authorised Service Centre, check if you
CAUTION!
An incorrect position of the
filters can cause bad
washing results and damage
to the appliance.

11.2 Cleaning the spray arms

Do not remove the spray arms. If the
holes in the spray arms are clogged,
remove remaining parts of soil with a thin
pointed object.

11.3 External cleaning

• Clean the appliance with a moist soft
cloth.
• Only use neutral detergents.
• Do not use abrasive products,
abrasive cleaning pads or solvents.

11.4 Internal cleaning

• Carefully clean the appliance,
including the rubber gasket of the
door, with a soft moist cloth.
• If you regularly use short duration
programmes, these can leave
deposits of grease and limescale
inside the appliance. To prevent this,
we recommend to run long duration
programmes at least 2 times per
month.
can solve the problem by yourself with
the help of the information in the table.