Cleaning The Spray Arms; External Cleaning; Internal Cleaning; Troubleshooting - Electrolux GA45GLVCN Benutzerinformation

16 www.electrolux.com
3. Remove the filter (B).
4. Wash the filters with water.
5. Before you put the filter (B) back,
make sue that there are no residues of
food or soil in or around the edge of
the sump. (C).
Make sure that the filter (B) is correctly
positioned under the 2 guides (C).
6. Assemble the filter (A) and put it into
position in filter (B). Turn it clockwise
until it locks.

12. TROUBLESHOOTING

If the appliance does not start or it stops
during operation. Before you contact an
Authorised Service Centre, check if you
can solve the problem by yourself with the
help of the information in the table.
Problem and alarm code Possible solution
You cannot activate the ap-
pliance.
CAUTION!
An incorrect position of the
filters can cause bad washing
results and damage to the
appliance.

11.2 Cleaning the spray arms

Do not remove the spray arms. If the holes
in the spray arms are clogged, remove
remaining parts of soil with a thin pointed
object.

11.3 External cleaning

• Clean the appliance with a moist soft
cloth.
• Only use neutral detergents.
• Do not use abrasive products, abrasive
cleaning pads or solvents.

11.4 Internal cleaning

• Carefully clean the appliance, including
the rubber gasket of the door, with a
soft moist cloth.
• If you regularly use short duration
programmes, these can leave deposits
of grease and limescale inside the
appliance. To prevent this, we
recommend to run long duration
programmes at least 2 times per
month.
With some problems, the display
shows an alarm code.
• Make sure that the mains plug is connected to the
mains socket.
• Make sure that there is no a damage fuse in the fuse
box.