Spektrum SPMAR9130T PowerSafe Bedienungsanleitung Seite 9

1. Using foam or thick double-sided foam tape and tie wraps, secure the
main PowerSafe unit in the position where you would normally mount the
receiver.
2. Mount the switch on the side of your aircraft and insert the switch plug in the
port in the main unit marked SWITCH.
The PowerSafe receiver uses a specifically designed switch. Conventionally wired
switches are not compatible with the PowerSafe receiver.
Installing Optional X-Plus 8 Module
When using an X-Plus
- it's built into the receiver) it is recommended the X-Plus 8 module be mounted
as close to the receiver as possible. When using the X-Plus power jumper lead
mounting the X-Plus 8 module close will minimize the current loss from the
receiver. Servo extensions can be use with each servo, it is recommended to use
heavy 22 gauge wire with gold plated connectors.
If an auxiliary battery or batteries are to be used there is no need for the X-Plus
power jumper. The X-Plus 8 module can be mounted as far away from the
receiver when using the auxiliary power option.
X+1
X+2
X+3
X+4
X+5
X+6
Installing the Batteries
Using the given guidelines select the battery system that best fits your application
and install the battery(s)/regulator(s) in your aircraft. Connect the battery(s) to the
PowerSafe receiver. Spektrum batteries are pre-wired with an EC3™ connector
and plug directly in. If using another brand of battery it will be necessary to solder
EC3 connectors (two are included with these PowerSafe receivers) to the battery
leads. If using a regulator, install it per the guidelines included with the regulator.
receiver and module (Not compatible w/ the AR20300T
™
9
EN
X+7
X+8
BATT/JMPR
BATT/JMPR
SRXL