Spektrum SPMAR9130T PowerSafe Bedienungsanleitung Seite 100

EN
Binding
NOTICE: In order for the system to operate, one remote receiver must be
connected. If an additional remote receiver is added after initial binding, the
system must be re-bound to recognize the additional remote receiver.
How To Bind the PowerSafe Receiver
The AR9140T, AR12310T and AR20310T PowerSafe receivers must be bound
to the transmitter before they will operate. Binding is the process of teaching
the receiver the specific code of the transmitter so it will only connect to that
specific transmitter.
1. Connect the remote receivers and any telemetry sensors to the main
receiver.
2. Push and hold the bind button on the PowerSafe receiver while turning on
the soft switch. Release the Bind button once all the LEDs on the receiver
and remote receivers start to flash continuously.
Tip: It is still possible to use a bind blug in the BIND port if desired.
3. Put your transmitter in bind mode.
4. The bind process is complete when all the orange LEDs are solid.
NOTICE: If using a bind plug, remove the bind plug after binding to prevent
the system from entering bind mode the next time the power is turned on.
5. After you set up your model, always rebind the transmitter and receiver
to set the desired failsafe positions. See FAILSAFE on the next page.
12