Spektrum SPMAR9130T PowerSafe Bedienungsanleitung Seite 13

Failsafe
The AR9130T, AR12300T and AR20300T PowerSafe receivers features two
types of failsafe: SmartSafe™ and Preset Failsafe.
Failsafe position is set during binding. In the unlikely event that the radio link
is lost during use, the receiver will drive all channels to its pre-programmed
failsafe position.
Receiver Power Only
When the receiver only is turned on (no transmitter signal is present), all servos
except for the throttle are driven to their preset failsafe positions, normally all
control surfaces at neutral and the landing gear down. These failsafe positions
are stored in the receiver during binding. At this time the throttle channel has
no output, to avoid operating or arming an electronic speed control (if used).
In glow-powered models, the throttle servo has no input so it remains in its
current position. The receiver remains in standby mode with the blue battery
LEDs lit. When the transmitter is turned on, the receiver locates the signal
(GUID), connects and normal control resumes. When connected, the amber
LEDs on all attached remote receivers will be on.
SmartSafe + Hold Last
If loss of signal occurs, SmartSafe™ technology moves the throttle channel to its
preset failsafe position (low throttle) that was set during binding. All other channels
hold their last position. When the receiver detects signal from the transmitter, normal
aircraft operation resumes.
Tip: Use either the built in BIND button OR a bind blug in the BIND/BATT port.
SmartSafe + Hold Last
1 Lower Throttle on transmitter
2 Push and Hold Bind Button
3 Power on Receiver
4 Release Button once RX goes into Bind Mode (flashing LED)
5
Place transmitter in Bind Mode and finish Binding.
A*
Install bind plug (optional)
B*
Leave in through entire bind process*
*Setting Failsafe can be done with the Bind Plug if desired.
**Remove Bind Plug when finished setting up Failsafe.
13
EN