Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Preset Failsafe
Preset failsafe is ideal for sailplanes, allowing the aircraft to automatically
dethermalize if the signal is lost. With preset failsafe, all channels go to their
preset failsafe positions if the signal is lost, preventing a flyaway. When the
receiver detects a signal from the transmitter, normal aircraft operation resumes.
Preset Failsafe
Move all sticks and switches on the transmitter to desired Failsafe
1
position.
2
Push and Hold Bind Button
3
Power on Receiver
4
Release Button after RX goes into Bind Mode (flashing LED)
Push and Hold the Bind Button again before the transmitter enters
5
Bind Mode.
A*
Install bind plug (optional)
B*
Remove plug once RX goes into Bind Mode
*Setting Failsafe can be done with the Bind Plug if desired.
**Remove Bind Plug when finished setting up Failsafe.
Range Testing
Before each flying session, and especially with a new model, it's important to
perform a range check. All Spektrum aircraft transmitters incorporate a range
testing system, which reduces the output power to allow a range check.
1. With the model resting on the ground, stand 30 paces (approx. 90 feet/28
meters) away from the model.
2. Face the model with the transmitter in your normal flying position and put your
transmitter into range test mode. This causes reduced power output from the
transmitter.
3. You should have total control of the model in range test mode at 30 paces
(90 feet/28 meters).
4. If control issues exist, call Horizon Product Support for further assistance.
Advanced Range Testing
The Standard Range Testing procedure is recommended for most sport aircraft.
For sophisticated aircraft that contain significant amounts of conductive materials
(e.g. turbine powered jets, some types of scale aircraft, aircraft with carbon
fuselages, etc.), the following advanced range check will confirm that all remote
14
Werbung
Inhaltsverzeichnis
