Setting Water Hardness; Setting Language - Philips HD5730 Handbuch

 You can put a special cleaning tablet into the ground coffee funnel.
5 Fill the water tank to the MAX level.
6 Put a bowl with a minimum capacity of 1.5 litres under the spout.
 Press the OK button.
The cleaning cycle takes up to 15 minutes if the water tank is filled to the
MAX level.
The message 'APPLIANCE IS CLEANING' appears on the display
,
and the cleaning cycle starts
When the cleaning cycle is finished, the message 'CLEANING
,
DONE' appears on the display.

setting water hardness

1 Remove the Total Hardness Test strip (attached to page ) from its
wrap. Dip the strip fully into the tap water you use to brew coffee.
Keep the strip in the water for a few seconds. Then remove the strip,
shake off excess water and wait approx. 0 seconds (until it changes
colour and one or more squares turn red).
 Press the MENU button.
The button lights up.
,
 Press the ^ button until the message 'SET WATER HARDNESS?'
appears on the display.
 Press the OK button.
5 Press the ^ button until the number on the display coincides with
the number of red squares on the test strip.
For example, if 3 squares on the test strip have turned red, you have to set
water hardness 3.
6 Press the OK button to confirm the set water hardness.
The coffee maker is now programmed to display the 'PLEASE
,
DESCALE!' message based on the actual hardness of the water you
use.

setting language

1 Press the MENU button.
The button lights up.
,
EnglisH