Setting Water Hardness - Philips HD5720 Bedienungsanleitung

EnglisH
0
cleaning
Regular cleaning prolongs the life of the appliance and guarantees optimal
brewing results for a long time.
1 Press the MENU button.
The button lights up.
,
 Press the ^ button until the message
'START CLEANING?' appears on the display.
 Press the OK button.
The message 'ADD DETERGENT - Push OK when ready-' appears
,
on the display.
 You can put a special cleaning tablet into the ground coffee funnel.
5 Fill the water tank to the MAX level.
6 Put a bowl with a minimum capacity of 1.5 litres under the coffee
spout.
 Press the OK button.
The cleaning cycle takes up to 15 minutes if the water tank is filled to the
MAX level.
The message 'APPLIANCE IS CLEANING' appears on the display
,
and the cleaning cycle starts
When the cleaning cycle is finished, the message 'CLEANING
,
DONE' appears on the display.

setting water hardness

1 Remove the Total Hardness Test strip (attached to page ) from its
wrap. Dip the strip fully into the tap water you use to brew coffee
for a few seconds. Remove it and wait approx. 0 seconds (until one
or more squares turn red).
 Press the MENU button.
The button lights up.
,
 Press the ^ button until the message 'SET WATER HARDNESS?'
appears on the display.
 Press the OK button.
5 Press the ^ button until the number on the display coincides with
the number of red squares on the test strip.
For example, if 3 squares on the test strip have turned red, you have to set
water hardness 3.
6 Press the OK button to confirm the set water hardness.