Dispensing Coffee; Programming The Quantity Of Coffee In A Cup; Saving Energy; Daily Cleaning - Caffitaly System S16 Bedienungsanleitung

• Raise the lever to open the capsule compartment (Fig. 1).
• Insert the capsule, pressing it gently in place (Fig. 2).
• Close the lever fully (Fig. 3).
• Place a cup or espresso cup under the coffee dispenser (Fig. 7 or 8).
• Press and release button A or B, depending on the desired coffee.
• The pressed button will blink. The machine will stop dispensing on reaching the programmed
quantity and emit a beep.
• Raise the lever to eject the used capsule into the drawer (Fig. 1).
• Close the lever (Fig. 3).
NB: The quantity of coffee dispensed can be programmed according to personal tastes
and the size of the cups or cups used.
To program the quantities, please refer to the section "Programming the quantity of coffee
in the cup".

Programming the quantity of coffee in a cup

• Raise the lever to open the capsule compartment (Fig. 1).
• Insert the capsule, pressing it gently in place (Fig. 2).
• Close the lever fully (Fig. 3).
• Place a cup or espresso cup under the dispenser (Fig. 7 or 8).
• Press and hold the desired coffee button.
• On reaching the desired quantity of coffee, release the button. Now the button is programmed.
The quantity of coffee dispensed can be programmed from a minimum of 20 up to a
maximum of 250 ml.
• Raise the lever to eject the used capsule into the drawer (Fig. 1).
• Close the lever (Fig. 3).
The machine will automatically reduce consumption after 1 hour of inactivity. Buttons
A-B-C blink slowly and sequentially. To restore normal operating conditions, press any
button or raise the lever. The appliance will start heating.
When the buttons A-B-C light up steady, the machine is ready to use.
• Remove the drip tray and used capsule drawer (Fig. 6).
• Lift the used capsule drawer (Fig. 11); empty and rinse it.
• Remove the grill and its support (Fig. 12). Lift the drip tray; empty and rinse it.
• Remove the water tank (Fig. 5); empty and rinse it.
NB: Traces of the product just dispensed may remain in the circuit of the machine. To
retain maximum beverage fl avour it is advisable to do a short rinse when dispensing milk,
hot chocolate or instant drinks. Rinsing is done by pressing any button (A, B or C), without
having inserted the capsule.
It is advisable to carry out this procedure in any case at least once a week.
Use a soft cloth and a neutral
detergent to clean the surfaces
of the appliance. Do not use jets
of water to clean the appliance.
English

Dispensing coffee

Saving energy

Daily maintenance

The plastic parts of the machine,
including the water tank, are NOT
dishwasher safe.
19