Descaling - Caffitaly System S16 Bedienungsanleitung

Descaling signal: When the indicator D blinks YELLOW and 3 beeps sound, it is advisable
to carry out the descaling cycle, as described below.
The machine features an advanced program that monitors how much water is used
to dispense beverages. This monitoring process provides the user with indications
as to when the machine needs to be descaled.
It is advisable to use the Caffi taly System descaling agent, designed to comply with
the technical characteristics of the machine, in full observance of consumer safety. The
descaling agent must be disposed of in compliance with the manufacturer's instructions
and/or the current regulations in force in the country where the appliance is used.
CAREFULLY
Avoid contact with eyes, skin and machine surfaces.
Switch the machine off during descaling, and do not lift the lever. A person must be
present during the operation.
Do not use vinegar: it could damage your machine!
• Switch the machine off by pressing the power on/off switch (Fig. 14).
• Empty and rinse the used capsule drawer and drip tray (Fig. 6).
• Remove and empty the water tank (Fig. 5).
• Mix the contents of a bottle of Caffi taly System descaling agent with approximately 750
cc. of water (a total of 1 litre) and pour into the tank.
• Make sure the lever is lowered (Fig. 3) and that there is no capsule inside the capsule
compartment.
• Remove the drip-tray (Fig. 15).
• Place a container (at least 500 ml) under the dispenser (Fig. 16).
• Press and hold buttons A and B while switching the machine on by pressing the main
switch.
• The button B is lit up, whereas the indicator D blinks YELLOW and REDalternately.
• Press button B to start the descaling cycle.
• The machine dispenses the descaling solution at intervals (5 dispensings with a pause
of 4 minutes, for a duration of approx. 25 minutes). During this phase, in which the
buttons must not be pressed, the indicator D blinks YELLOW and RED alternately.
• If the container fi lls up, empty it.
• When the fi rst phase is completed, the button B lights up and a beep sounds. The water
tank is empty.
• Carefully rinse the water tank and refi ll it with fresh water (Fig. 4).
• Empty and rinse the used capsule drawer and the container used, and put them back in
place (Fig. 16).
• Press the button B to start the rinse cycle.
• Rinse water (about 500 ml) will be run through the machine. During this phase the
indicator D blinks YELLOW and RED alternately.
• When the rinse cycle is completed, a beep sounds and the buttons A-B-C blink
simultaneously; the machine is in the heating phase
• When the buttons light up steady and 2 beeps sound, the appliance is ready to use.
• Carefully empty and rinse the water tank and refi ll it with fresh, plain water (Fig. 4).
• Empty and rinse the used capsule drawer and put it back together with the drip tray.
20
English

Descaling

read the precautions provided on the descaling product package.