Correct Use Of The Buttons; Dispensing Coffee; Programming The Quantity Of Coffee In A Cup - Caffitaly System S21 Bedienungsanleitung

To dispense "Espresso" or "Caffè crema", use solely buttons A or B (1st and 2nd from the top
respectively, lit in WHITE). The same buttons, depending on the quantity, are to be used for
dispensing capsules of orzo, ginseng, cocoa or milk.
Button C (3rd from the top, lit in BLUE) must be used solely for "Filter coffee" or "Americano"
(very mild). This same button can be used for capsules of tea, chamomile tea or herbal tea.
Do not use button C for espresso or any other coffee with an intense fl avour. In this function
the machine is set for low pressure and this reduces the "crema", diminishes the fl avour of the
coffee, and could cause a break in the fl ow.
NOTE: Traces of the product just dispensed may remain in the circuit of the machine.
To retain maximum beverage fl avour it is advisable - when dispensing milk, hot
chocolate or instant drinks - to perform a short rinse. Rinsing this
using one of the cleaning capsule supplied and pressing any button (A ,B or C).
We would advise you to carry out this procedure at least once a week in any
case.
• Raise the lever to open the capsule compartment (Fig. 1).
• Insert the capsule, pressing it gently into place (Fig. 2).
• Close the lever fully (Fig. 3).
• Place a cup or espresso cup under the coffee dispensing spout (Fig. 7 or 8).
• Press and release button A or B, depending on the desired coffee.
• The pressed button will blink. The machine will stop dispensing on reaching the
programmed quantity and emit a beep.
• Raise the lever to eject the used capsule into the drawer (Fig. 1).
• Close the lever (Fig. 3).
NOTE: the quantities of coffee dispensed may be programmed according to
personal taste, and the size of the cup or mug used.
To program the quantities, please refer to ch. "Programming the quantity of coffee
in a cup".

Programming the quantity of coffee in a cup

• Raise the lever to open the capsule compartment (Fig. 1).
• Insert the capsule, pressing it gently into place (Fig. 2).
• Close the lever fully (Fig. 3).
• Place a cup or espresso cup under the dispensing spout (Fig. 7 or 8).
• Press and hold the desired coffee button.
• On reaching the desired amount of coffee, release the button. Now the button is
programmed. The quantity of coffee dispensed can be programmed from a minimum
of 20 up to a maximum of 250 ml.
• Raise the lever to eject the used capsule into the drawer (Fig. 1).
• Close the lever (Fig. 3).
20
English

Correct use of the buttons

Dispensing coffee

is performed