Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
•
Raise the lever to open the capsule compartment (Fig. 1).
•
Insert the capsule, pressing it gently into place (Fig. 2).
•
Close the lever fully (Fig. 3).
•
Place a cup or espresso cup under the coffee dispensing spout (Fig. 7 or 8).
•
Press and release button A or B, depending on the desired coffee.
•
The pressed button will blink. The machine will stop dispensing on reaching the pro-
grammed quantity and emit a beep.
•
Raise the lever to eject the used capsule into the drawer (Fig. 1).
•
Close the lever (Fig. 3).
NOTE: the quantities of coffee dispensed can be programmed according to personal
taste and the size of the cups or espresso cups used.
To program the quantities, please refer to ch. "Programming the quantity of coffee in
a cup".
Programming the quantity of coffee in a cup
•
Raise the lever to open the capsule compartment (Fig. 1).
•
Insert the capsule, pressing it gently into place (Fig. 2).
•
Close the lever fully (Fig. 3).
•
Place a cup or espresso cup under the dispensing spout (Fig. 7 or 8).
•
Press and hold the desired coffee button.
•
On reaching the desired amount of coffee, release the button; the machine will beep
three times. Now the button is programmed. The quantity of coffee dispensed can be
programmed from a minimum of 20 up to a maximum of 250 ml.
•
Raise the lever to eject the used capsule into the drawer (Fig. 1).
•
Close the lever (Fig. 3).
The machine will automatically reduce consumption after 10 minutes of inactivity.
Buttons A-B-C blink WHITE slowly and sequentially. To restore normal operating
conditions, press any button or raise the lever. The appliance will start warming up.
When buttons A-B-C turn on and remain steadily lit, the appliance is ready for use.
•
Remove the drip tray and used capsule drawer (Fig. 6).
•
Lift the used capsule drawer (Fig. 11); empty and rinse it.
•
Remove the grid (Fig. 12). Empty the drip tray and rinse it out with water.
•
Remove the water tank (Fig. 5); empty and rinse it.
NOTE: traces of the product just dispensed may remain inside the machine. When
dispensing milk, hot chocolate or instant beverages, for full fl avour we suggest
rinsing the machine by pressing any button (A , B or C) without inserting a capsule.
In any case, we recommend carrying out this procedure daily or at least every
ten dispensings or before a long period of appliance disuse.
Use a soft cloth and a neutral deter-
gent to clean the surfaces of the appli-
ance. Do not use jets of water to clean
the appliance.
English
Dispensing coffee
Saving energy
Daily maintenance
The plastic parts of the machine,
including the water tank, are NOT
dishwasher safe.
33
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
