Troubleshooting; Troubleshooting Pole Pruner And Battery - Stihl HTA 65 Gebrauchsanleitung

19 Troubleshooting

19 Troubleshooting

19.1 Troubleshooting Pole Pruner and Battery

Condition LEDs on Battery
Pole pruner does not 1 LED flashes
run when switched green
on.
1 LED glows red. Battery too hot or too cold. ► Remove the battery.
3 LEDs flash red. There is a malfunction in
3 LEDs glow red
4 LEDs flash red. There is a malfunction in
Pole pruner cuts out 3 LEDs glow red
during operation.
0458-766-9921-B
Cause
Battery has low charge.
the pole pruner.
The pole pruner is too hot. ► Remove the battery.
the battery.
No electrical contact
between pole pruner and
battery.
Pole pruner or battery
damp.
The pole pruner is too hot. ► Remove the battery.
Remedy
► Recharge the battery fully as described in the
instruction manual for the STIHL AL 101, 300, 500
chargers.
► Allow battery to cool down / warm up.
► Remove the battery.
► Clean contacts in battery compartment.
► Fit the battery.
► Switch on the pole pruner.
► If 3 LEDs continue to flash red: Do not use your
pole pruner and contact your STIHL servicing
dealer for assistance.
► Allow the pole pruner to cool down.
► Remove battery and insert it again.
► Switch on the pole pruner.
► If 4 LEDs continue to flash red: Do not use the
battery and contact your STIHL dealer for
assistance.
► Remove the battery.
► Clean contacts in battery compartment.
► Fit the battery.
► Allow pole pruner or battery to dry.
► Allow the pole pruner to cool down.
English
65