Installing The Electrical Supply Lines - Dometic COOLAIR SP950T Montageanleitung

CoolAir SP950T
6.5

Installing the electrical supply lines

!
WARNING!
• The electrical power supply may only be performed by qualified personnel
with specialist knowledge.
• Make sure there is no voltage present on electrically operated components
before carrying out work on them!
A
NOTICE!
• Fit a fuse of 30 A to the connection to the vehicle's power supply.
• The battery must be able to supply the required current and voltage
(chapter "Technical data" on page 26).
You can connect the unit to the battery via the lorry's terminal block or directly.
The direct connection to the battery is preferred. Ask your vehicle manufacturer
for the specifications of the terminal block.
For connecting to the battery, proceed as follows:
➤ Plug the connection cable into the socket of the parking cooler supply line.
➤ Secure the connection cable with a cable tie, e.g. to the cab roof.
➤ Lay the connection cable for the battery box in a protected place.
➤ Trim the negative cable (black) to length if necessary and attach an
appropriate ring terminal.
➤ Connect the negative cable (black) directly to the negative terminal of the
battery.
I
NOTE
Place the fuse holder no more than 0.3 m from the positive terminal of the
battery.
➤ Attach the fuse holder in a suitable location.
➤ Lay the positive cable (red) to the fuse holder and trim.
➤ Trim the shorter connection cable from the fuse holder to the correct length
and connect with a joint connector on the positive cable (red).
➤ Insulate the connection cable with the joint connectors properly.
➤ Trim the longer connection cable from the fuse holder if necessary and fit a
suitable ring terminal.
➤ Connect the longer connection cable from the fuse holder with the ring
terminal directly to the positive terminal of the battery.
EN
Installation
19