Kemper PROFILER Grundlagen Anleitung Seite 12

12 KEMPER PROFILER
The above assumes that you are miking the speaker cabinet connected to your reference amp. If you are taking
a direct, cabinet-simulated output, either from the amp itself, or from a speaker load box such as the Hughes &
Kettner Redbox™ or Palmer™ boxes, you can connect the line-out from a load box directly to the RETURN INPUT
of your Profiler.
The reference amp has to be connected to the Profiler in such a way that only the Profiler will send and receive
the signals. This effectively turns the Profiler into a monitoring device.
Avoid any other connections that might lead to confusion and end up corrupting the results. For example, if you
want to use several microphones with your reference amp, you should route the signals of these microphones to
a subgroup of your mixer, and then route the output of that subgroup directly to the profiling input. You can use
the EQ and phase switches on the mixer to optimize the mix. Make sure that the signal is only routed to the Pro-
filer and isn't duplicated at the main outs of the mixer.
Guitar Input
Direct Out/
Send
Main Outs Input
Return