In-Place Sanitization; Routine Maintenance; Maintenance (To Be Carried Out By Qualified Service Personnel Only) - Ugolini HT 10 Gebrauchsanweisung

downwards (2) till it is arranged (see figure 15).
5 - Replace the faucet top cover.

5. 4 IN-PLACE SANITIZATION

The In-Place Sanitization prior to starting the machine may
be performed, if needed, only as further precaution, in
addition to the Disassembled Parts Sanitization described
before, but never in lieu of it.
1 - Prepare two gallons of a warm (45-60°C, 120-140 °F)
s a ni t iz i n g s o l u t i o n ( 1 0 0 P P M a v a i la b l e c h l o r i n e
concentration or 1 spoon of sodium hypoclorite diluted with
two litres of water) according to your local Health Codes
and manufacturer's specifications.
2 - Pour the solution into the bowl(s).
3 - Using a brush suitable for the purpose, wipe the solution
on all surfaces protruding above the solution-level and on
the underside of the top cover(s).
4 - Install the top cover(s) and operate the unit. Allow the
solution to agitate for about two minutes. Drain the solution
out of the bowl(s).
5 - Use fresh product to chase any remaining sanitizer from
the bowl(s). Drain this solution. Do not rinse out the
machine.

6 ROUTINE MAINTENANCE

Daily: inspect the machine for signs of product leaks past seals
and gaskets. If proper assembly does not stop leaks around
seals or gaskets, check for improper lubrication, worn or
damaged parts. Replace parts as needed with original spare
parts from the supplier.
6. 1 MAINTENANCE (TO BE CARRIED OUT
BY QUALIFIED SERVICE PERSONNEL
ONLY)
Montly: clean all internal components, primarily the
condenser, using compressed air.
To clean these internal parts, unplug the unit or switch off the
2-pole wall breaker, then remove front panel (dispensing side).
Condenser fins are very sharp. Use extreme caution when
cleaning.
When installed, the anti-splash filters inside the slotted panels
must not be removed.
Ugolini S.p.A.
figure 15
HT10 - HT11 - HT20
17