Ht11 - Ht20 Lines With Gravity Faucet; Ht10 Line; Cleaning - Ugolini HT 10 Gebrauchsanweisung

5. 3. 2. 3 HT11 - HT20 LINES WITH GRAVITY
FAUCET
1 - Estract (1) the piston and then remove (2-3) the faucet
handle (see figure 6).
2 - Take the bowl away from the machine and turn it upside
down. Remove the faucet body from the bowl (see figure
7).

5. 3. 2. 3 HT10 LINE

1 - Remove the faucet top cover.
Push (1) the dispensing handle and remove the pinch tube
from its vertical seat (2) in the faucet body and from its
horizontal one (3) from the bowl bottom (see figure 8).
2 - Take the bowl away from the machine and turn it upside
down.
Ugolini S.p.A.
figure 6
figure 7
figure 8
Pull (1) the tab release lever and at the same time, turn to
the left (counterclockwise) the faucet body till it gets free,
together with faucet cover, from the bowl (see figure 5).

5. 3. 3 CLEANING

ATTENTION
Before any disassembly and/or cleaning procedure
make sure that the dispenser is disconnected from its
power source.
IMPORTANT
Do not attempt to wash any machine components in a
dishwasher.
1 - Prepare at least two gallons of a mild cleaning solution of
w a r m ( 4 5 - 6 0 ° C 1 2 0 - 1 4 0 ° F ) p o t a b l e w a t e r a n d
dishwashing detergent. Do not use abrasive detergent.
Important: if present, follow label directions, as too strong
a solution can cause parts damage, while too mild a
solution will not provide adequate cleaning.
IMPORTANT
In order to prevent any damages to the dispenser use
only a detergent suitable with plastic parts.
2 - Using a brush, suitable for the purpose, thoroughly clean
all disassembled parts in the cleaning solution.
ATTENTION
When cleaning the machine, do not allow excessive
amounts of water around the electrically operated
components of the unit. Electrical shock or damage to
the machine may result.
3 - Do not immerse the lighted top covers in liquid. Wash them
apart with the cleaning solution. Carefully clean their
undersides.
4 - In the same manner clean the evaporator cylinder(s) using
a soft bristle brush.
5 - Rinse all cleaned parts with cool clean water.
5. 3. 4 SANITIZING
Sanitizing should be performed immediately prior to
starting the machine. Do not allow the unit to sit for
extended periods of time after sanitization.
1 - Wash hands with a suitable antibacterial soap.
2 - Prepare at least two gallons of a warm (45-60 °C 120-
140 °F) sanitizing solution (100 PPM available chlorine
concentration or 1 spoon of sodium hypoclorite diluted with
two litres of water) according to your local Health Codes
and manufacturer's specifications.
3 - Place the parts in the sanitizing solution for five minutes.
4 - Do not immerse the lighted top covers in liquid. Carefully
wash their undersides with the sanitizing solution.
5 - Place the sanitized parts on a clean dry surface to air dry.
6 - Wipe clean all exterior surfaces of the unit. Do not use
abrasive cleaner.
HT10 - HT11 - HT20
15