Werbung
Verfügbare Sprachen
Verfügbare Sprachen
300 SERIES
U s e r m a n u a l
Mounting the loudspeaker
300ICW products of the 300 Series include a mounting frame, a 300ICW loudspeaker and both circular
and square magnetic grilles. No tools are required to mount the 300ICW loudspeakers of the 300 Series
range.
1. Pivot the mounting bracket until it clips onto the mounting frame so that the mounting frame can be
pushed through the opening (fig. 1).
2. With one hand, insert the mounting frame into the opening in the ceiling/wall, making sure it rests
flush against the ceiling/wall (fig. 2).
3. To fasten the mounting frame to the ceiling/wall, insert your other hand into the opening, and use two
fingers to pivot the mounting bracket to the opposite side to its initial position (fig. 3)
4. Push the mounting bracket down until it reaches the stop (fig. 4).
5. Finally, release the mounting bracket making sure it is securely in place. Also make sure the mounting
bracket isn't resting on the loudspeaker cable (fig. 5).
Note 1: repeat the operation for the other mounting brackets.
Note 2: to unlock the mounting bracket: use two fingers to pivot the mounting bracket towards the
outside, pull upwards and release.
6. Connect the previously stripped loudspeaker wires to the spring loaded terminals on the loudspeaker. It is
essential to connect the loudspeakers respecting the correct polarity: the cable connected to the "+"
terminal on the amplifier must be connected to the red terminal on the loudspeaker. Likewise, the
cable connected to the "-" terminal on the amplifier must be connected to the black terminal on the
loudspeaker. Stereo image and bass perception would be seriously compromised if these conditions
were not respected (fig. 6).
7. The loudspeakers are now ready to be assembled to the mounting frame. In order to do this, posi-
tion the red arrows on the loudspeaker in line with the open padlocks on the mounting frame (fig. 8).
Note: if you plan to use your product as in-ceiling loudspeakers, the loudspeaker can be securely fas-
tened to the ceiling using a safety sling (not supplied) which fastens to the hook on the rear of
the product (fig. 6).
8. Insert the loudspeaker into the mounting frame (fig. 7) until the stop, then pivot the loudspeaker
using the red handles so that the markers are positioned between two open padlocks (fig. 9).
9. The circular or square grilles can now be mounted to the loudspeaker. The grille is held to the mount-
ing frame magnetically, all you need to do is simply line them up (fig. 10).
14
Werbung
