Inhaltsverzeichnis
Werbung
Termocamino 650 - 800
CHIMNEY CAP: DISTANCES AND POSITIONING UNI 10683/98
Roof slope
α
15°
30°
45°
60°
6. CONNECTION TO THE FLUE
The connection to the flue (exhaust channel or pipe fitting) must be made using rigid pipes in aluminium
plated steel with minimum thickness of 2 mm or in 316 stainless steel with minimum thickness of 1 mm.
It is prohibited to use flexible metal pipes or asbestos cement pipes because they are subject to
splitting or breakage, which can lead to fume leakage, jeopardising the safety of the connection
itself.
The exhaust venting pipe must be hermetically fixed to the chimney and can have a maximum inclination of
45° ; this is to prevent excessive condensate deposi ts produced in the initial lighting phase and/or
excessive settling of soot, and also prevents the slowing of the vented fumes.
A connection that is not hermetically sealed can cause the appliance to malfunction.
The internal diameter of the connection pipe must correspond to the external diameter of the exhaust pipe
on the appliance. This is guaranteed by pipes to DIN 1298 standard.
The depression to the chimney must be 17 -20 Pa (1.7 – 2 mm of column of water).
The measurement must always be made with the appliance warm (nominal heat yield).
When depression exceeds 20 Pa (2 mm of column of water), it is necessary to reduce it by installing a
supplementary draught regulator (butterfly valve) into the discharge pipe or into the chimney.
Instruction Manual – Rev.07 – EN
>A
min. H
(1)Ridge axis
colmo
α
Distance between roof ridge and
chimney
A (m)
< 1,85 m
> 1,85 m
< 1,50 m
> 1,50 m
< 1,30 m
> 1,30 m
< 1,20 m
> 1,20 m
> _ A
0.5 m
(2)Roof
Minimum height of chimney
(measured from the outlet )
0.50 m above the ridge
1.00 m from roof
0.50 m above the ridge
1.30 m from roof
0.50 m above the ridge
2.00 m from roof
0.50 m above the ridge
2.60 m from roof
Picture 12
H (m)
27
Werbung
Inhaltsverzeichnis
