Rear Spacers; Removing The Transport Support - AEG S93880KMB3 Benutzerinformation

• The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the
domestic power supply socket is not
earthed, connect the appliance to a
separate earth in compliance with
current regulations, consulting a
qualified electrician.
• The manufacturer declines all
responsibility if the above safety
precautions are not observed.
• This appliance complies with the
E.E.C. Directives.

8.4 Rear spacers

Install the two spacers and the locking
pins provided within the accessory bag
as shown in the figure.
8.5 Levelling
When placing the appliance ensure that
it stands level. If necessary adjust the feet
using the adjustment spanner supplied.
Door alignment is dependent on proper
levelling.
8.6 Removing the transport
support
Your appliance is equipped with
transport support to secure the door
during transportation.
1. Open the door.
2. Remove the transport support (2)
from the door sides.
3. Remove the transport support (3)
from the lower hinge (some models).
3
4. Remove the transport support (4)
from underneath the water unit.
5. Cut the pump securing tie (5) and
remove it.
CAUTION!
Some models are fitted with
a silencing pad under the
cabinet. Do not remove this
pad.
8.7 Connecting the water
hose.
Water supply should be provided with a
tap and 3/4" male connector within 1,5 m
from the appliance.
ENGLISH 37
2
5
4