Door Reversibility - AEG S93880KMB3 Benutzerinformation

8.10 Installation of the water
filter.
1. Unpack the filter.
2. Remove the accessories in front of
the water module and open the
service hatch.
3. Place a cloth or a piece of kitchen
towel in the space beneath the water
filter.
4. Pull the bypass cartridge outwards,
grasping the lower part, until the
water bypass cartridge is
automatically ejected.
5. Remove the protective wrapping of
the new water filter and insert the
new filter firmly into the filter
connection.
6. Push the water filter back to its
original position.
7. Remove cloth or towel and make
sure that spilled water is wiped off.
8. Close the hatch and remount the
interior.
9. Keep the bypass cartridge for future
use.
10. Select Still cold water and dispense
about 2 litres of water. There may be
some air to start with.
1
8.11 Installation of the gas
cylinder.
If the gas cylinder is already
installed, remove the
transport support and turn
the lever upwards. Refer to
point 3.
1. Remove the gas cylinder wrapping
and screw on the adapter to the gas
cylinder. Tighten by hand only.
2. Position the gas cylinder with the
3. Turn the lever upwards in one
2

8.12 Door reversibility

In case you want to change the opening
direction of the door, contact the nearest
Authorised Service Centre. The
Authorised Service specialist will carry
out the reversibility of the doors at your
cost.
adapter attached underneath the
valve and ensure that the hooks of
the lever system supports the
protruding parts of the adapter.
2
1
continuous movement.
3
ENGLISH 39
4