Technical Data; Closing The Door; Installation; Rear Spacers - AEG S32440KSW0 Benutzerinformation

14

Technical data

7. Connect the mains plug to the mains socket.
8. Open the door. Make sure that the lamp comes on.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
TECHNICAL DATA
Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.

INSTALLATION

WARNING!
Read the "Safety Information" carefully for your safety and correct operation of the appli-
ance before installing the appliance.
Positioning
This appliance can be installed in a dry, well ventilated indoor (garage or cellar) also, but for
optimum performance install this appliance at a location where the ambient temperature
corresponds to the climate class indicated on the rating plate of the appliance:
Climate class
SN
N
ST
T

Rear spacers

In the bag with the documentation, there are two spacers which must be fitted as shown in
the figure.
All manuals and user guides at all-guides.com
Height
Width
Depth
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
1250 mm
550 mm
612 mm
11 h
230 V
50 Hz
Ambient temperature