AEG S93880KMB3 Benutzerinformation Seite 34

34 www.aeg.com
Problem
The compressor does not
start immediately after
pressing the COOLMATIC,
or after changing the tem-
perature.
Water flows inside the refrig-
erator.
Water flows on the floor.
Temperature cannot be set.
DEMO appears on the dis-
play.
Door is misaligned or inter-
feres with ventilation grill.
There is not enough carbon
dioxide in the water.
There is too much carbon di-
oxide in the water.
No carbon dioxide.
No or very low water flow.
Possible cause
This is normal, no error has
occurred.
The water outlet is clog-
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
The COOLMATIC function
is switched on.
The appliance is in demon-
stration mode.
The appliance is not level-
led.
The carbon dioxide is run-
ning out.
The incoming water pres-
sure is too low.
Dilute with ordinary water.
The gas cylinder is empty.
The gas cylinder is empty.
Solution
The compressor starts after a
period of time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water out-
let to the evaporative tray.
Switch off COOLMATIC man-
ually, or wait until the function
resets automatically to set the
temperature. Refer to "
COOLMATIC function".
Keep the Mode pressed for
approximately 10 seconds un-
til a long sound is heard and
display shuts off for a short
time.
Refer to "Levelling".
Refer to "Installation of the
gas cylinder".
Drain off a large amount of
carbonated water (about 1 li-
tre).
Dilute with ordinary water.
(See "The functions of the wa-
ter dispenser" in "Control
Panel"" chapter).
Refer to "Selecting and dis-
pensing water".
Refer to "Replacing gas cylin-
der".
Refer to "Replacing gas cylin-
der".