Troubleshooting - Velleman CAMIP15 Bedienungsanleitung

CAMIP15
2. Enter your Seedonk username and password to view the
camera images on your pc. Create a new account if
necessary. (See fig. 18)
Seedonk iSecurity+
In the camera settings, you can access a trial version of
extra iSecurity+ software: it supports push notification and
Cloud video recording. (See fig. 19)
1. Press Yes to start the trial.
2. Define the motion sensitivity and switch on the motion
detection function.
For more details, visit www.seedonk.com
Attention
To prevent hacking or other interferences, if someone logs
into your account, a message appears on your mobile
device. (See fig. 20)

Troubleshooting

LED status indicators
green setup mode on
orange setup mode initialising
Wi-Fi setup
off setup mode off
green connected to iSecurity+
orange connected to local network
Network
flashing not connected to any
orange network
green power on
Power
Reset Button
To reset the camera:
1. Set the Wi-Fi setup switch on the back of the camera
to OFF.
2. Use a thin pin to press and hold the reset button for
about 10 seconds to reset the camera. (See fig. 21)
V. 02 – 14/05/2014 19 ©Velleman nv