Handle Winder Plunge - CMT ORANGE TOOLS CMT7E Bedienungsanleitung

EN
CUT DEPTH ADJUSTMENT
There are three methods of cut depth adjustment, depending on the accuracy and control required: Free
Plunge, for conventional & fast depth setting; Handle Winder Plunge, for controlled & fast adjustment;
and Micro Adjuster, for precise depth setting throughout the full plunge range.
FREE PLUNGE
1. Free plunge depth adjustments can be made with
the Plunge Mode Selector button engaged. Press
it deep inside the handle until it engages inward
Fig 6.
2. Release the Plunge Lock Lever (g). Push the body
of the router until the desired depth is reached.
Re-lock the plunge lock lever.
Note: The position of the plunge lock lever can be
altered by removing its retaining screw and reposi-
tioning the lever on the bolt. Re-tighten firmly.

HANDLE WINDER PLUNGE

1. Handle Winder Plunge depth adjustments
can be made when the plunge mode
selector button is flush with the handle.
If engaged, press the Plunge Mode Selector
button inward and allow it to spring out
flush with the handle. Ensure the Plunge
Lock Lever is unlocked Fig 8.
2. Pull the Winder Handle Clutch Ring into the
handle then turn the handle to raise or lower the cutter. Release the ring
at the required depth, allowing it to "pop out", locking the cutter at the
desired depth Fig 9.
3. Lock the plunge lever, particularly for heavy cuts.
MICRO ADJUSTER -
For use in the Handle Winder Plunge Mode only.
1. Disengage the Plunge Mode Selector button, and ensure that the plunge
lock lever is unlocked Fig 10a.
Note: If the micro winder is turned with the plunge lock lever engaged the
micro winder will start clicking and the cut depth will remain unchanged.
2. Turn the Micro Winder Adjuster Knob clockwise to increase cut depth
and anti-clockwise to reduce cut depth Fig 10b.
Note: When the end of the depth adjustment range is reached the micro
winder will offer greater resistance to turn and will begin to "click".
3. Lock the plunge lever, particularly for heavy cuts.
8 8
Fig. 6
Fig. 8
Fig. 10a
Fig. 10b
www.cmtutensili.com www.cmtutensili.com
Fig. 7
g
Fig. 9