CMT ORANGE TOOLS CMT7E Bedienungsanleitung Seite 10

EN
HAND-HELD OPERATION
• Always use both hands to control the router and ensure your
workpiece is securely clamped to prevent any movement
during operation. Fig. 18.
• Never operate the router free-hand without some form of
guidance. Guidance can be provided by a bearing guided
cutter, the fence guide supplied or a straight edge (eg. a
batten clamped to your work as shown in Fig. 18).
• Always feed against the direction of cutter rotation (clock-
wise, as indicated by the arrows on the router base). Fig. 19.
• Do not operate the router upside down unless securely
mounted in a well guarded router table (eg. CMT brand).
THE BASE ASSEMBLY
The Base (o) supplied with the CMT Router can be used as an
extended baseplate, as a fence or as a circle cutter.
FITTING THE FENCE
1. Loosen the Mounting Knobs (p) until they are approximately
10mm (3/8") above the base of the router.
2. Position the router inside the tabs on the Base (o), with the
knobs above the two keyhole slots. Note: the router can be
mounted with the long overhang to the left or to the right
depending on where the support is required. For edge work,
locate the power switch on the short overhang side of the
base, as shown in Fig. 23.
3. Push down on the mounting knobs until the bolt heads
locate into the keyholes, then slide the router until it sits
against the locating tabs. Fig. 21. Tighten the knobs firmly.
4. Loosen the Fence Knobs (q) a few turns and slide the Fence
(r) onto the base from the chosen end. Fig. 22. Lock at the
desired setting by tightening both fence knobs.
p
10 10
o
Fig. 18
Fig. 20
p
Fig. 21
www.cmtutensili.com www.cmtutensili.com
Fig. 19
q
r
q
Fig. 22