Synchronous Programming Mode; Stopping Programming Mode In Transmitter; Approaching End Positions Of Roller Shutter, Awning, Venetian Blind - weinor BiEasy 15M Bedienungsanleitung

1. Press the OPEN and DOWN keys and the programming
button P (back of the device) simultaneously (for 3
seconds) on a transmitter that is already programmed
for the receiver. The status display lights up briefl y. The
receiver is now in programming mode.
2. Press the programming button P on the transmitter to
be programmed, until the status display lights up briefl y.
The receiver is now in programming mode (movements
up and down).
3. Press the OPEN key immediately (maximum 1 second)
after an upward movement has started. The status
display lights up briefl y. The blind stops briefl y, starts
moving again, stops and then moves in the DOWN
direction.
4. Press the DOWN key immediately (maximum 1 second)
after the start of a downward movement. The status
display lights up briefl y. The blind stops.
The transmitter is now programmed.
If more than 10 bidirectional receivers are being
programmed at the same time, the transmitter channel in
programming mode switches to group mode. Group mode
is indicated by fast fl ashing with pauses.
Programming in group mode is terminated after 2 minutes
without pressing a key or the joystick or by pressing the
STOP key for 6 seconds.
Important:
For venetian blinds, a jogging mode for quickly reaching
receivers which are further away is not possible in a
transmitter channel with more than 10 programmed
receivers.
Ⓒ weinor GmbH & Co. KG
34 | EN

4.6.2 Synchronous programming mode

If a transmitter must be programmed for multiple receivers
at the same time:
1. Press the DOWN key and the programming button P
(back of the device) simultaneously (for 3 seconds)
on a transmitter that is already programmed for the
receivers. The status display fl ashes. The receivers
are now in programming mode.
2. Press the programming button P on the transmitter
to be programmed, until the status display lights up
briefl y. The receivers are now in programming mode
(movements up and down).
3. Press the OPEN key immediately (maximum 1 second)
after an upward movement has started. The status display
lights up briefl y. The blinds stop briefl y, start moving again,
stop and then move in the DOWN direction.
4. Press the OPEN key immediately (maximum 1 second)
after the start of a upward movement. The status display
lights up briefl y. The blinds remain stopped.
The transmitter is now programmed.

4.6.3 Stopping programming mode in transmitter

Press and hold the STOP key for at least 6 seconds until
the status display shows orange.
4.6.4 Approaching end positions of roller shutter,
awning, venetian blind
Condition:
The transmitter is now programmed. The end positions
have been set.
Ⓒ weinor GmbH & Co. KG
EN | 35