Operation Of Transmitter With Combio Ja Pulse; Deleting Positions/Deleting Transmitters - weinor BiEasy 15M Bedienungsanleitung

2. The blind travels to the stored intermediate position.
Venetian blinds are automatically tilted after reaching
the intermediate position if a tilting position has
been programmed. If an intermediate position is not
programmed, the blind moves down to the bottom end
position (not if Combio Pulse is used).
Approaching the ventilation/tilting position
Requirement
The transmitter is now programmed.
The blind/shutter is at its lower end position.
1. Press the OPEN button briefl y twice. The status display
lights up briefl y.
2. The blind travels to the stored ventilation / tilting position.
If a ventilation/tilting position is not programmed, the blind
moves down to the bottom end position (not if Combio
Pulse is used).

4.6.7 Operation of transmitter with Combio JA Pulse

A Combio-867 / -868 / -915 JA pulse for exact setting of
the slats can be used with venetian blind drives. Press the
OPEN or DOWN key to move for the preset pulse time of
the Combio Pulse.
The user can change the pulse time. This is done by
pressing and holding the STOP and OPEN keys for
6 seconds. The drive starts moving in short pulses. As soon
as the blind has moved the desired distance, release the
OPEN key then release the STOP key. The new pulse time
is saved. The new pulse time is equal to the total of all pulse
times while programming the pulse time. After 30 pulses the
Combio JA Pulse terminates programming the pulse time.
Ⓒ weinor GmbH & Co. KG
38 | EN

4.6.8 Deleting positions/deleting transmitters

Deleting the intermediate position in the receiver
1. Press both the STOP button and the DOWN button.
2. Press and hold this key combination for approx.
3 seconds. The status display lights up briefl y.
Deleting the ventilation/tilting position in the receiver
1. Press both the STOP button and the OPEN button.
2. Press and hold this key combination for approx.
3 seconds. The status display lights up briefl y.
Deleting the transmitter channel in the receiver
• Press both the STOP key and the programming button P
(back of the device).
3. Press and hold this key combination for approx.
6 seconds until the status display lights up briefl y orange
and then red.
The channel (or the group) in the transmitter is also
deleted.
Deleting all the transmitters in the receiver
1. Press the STOP key, the programming button P (back
of the device) and the OPEN key and the DOWN key
together.
2. Press and hold this key combination for approx.
6 seconds. The status display lights up orange-green
briefl y twice, followed by red.
The channel (or the group) in the transmitter is also
deleted.
Ⓒ weinor GmbH & Co. KG
EN | 39